3DHS SLICK 580 Instrukcja montażu - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Zabawka 3DHS SLICK 580. 3DHS SLICK 580 16 stron.

5. Locate the 2 threaded pushrods that are the same length and 4 micro ball

links along with 4 2mm bolts, nuts and washers. Thread the ball links onto

each end of the pushrods and secure to the servo arm and control horn with

the 2 mm hardware as shown in the picture. Use the longest arm provided

with your servo.

6. Repeat this process for the other wing half.

7. Locate the carbon fiber main landing gear, 2 axles, 2 washers, 2 locking

nuts, 2 wheels, 2 wheel collars and the 2 wheel pants from the hardware

package. Place the threaded portion of the axle through the hole in the

carbon gear, slide a washer over the threaded portion and screw the lock nut

onto the axle, but do not tighten completely. Place the wheel onto the axle and

secure with a wheel collar. There is a slot pre-cut in the wheel pant to allow

it to fit over the axle. Slide the wheel pant into position over the axle and

tighten the nut on the axle, taking care to make sure the wheel pant is

positioned properly. Repeat this process for the remaining wheel and wheel

pant. Again this is probably better explained in the following series of

pictures