3DHS SLICK 580 조립 설명서 - 페이지 7

{카테고리_이름} 3DHS SLICK 580에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DHS SLICK 580 16 페이지.

5. Locate the 2 threaded pushrods that are the same length and 4 micro ball
links along with 4 2mm bolts, nuts and washers. Thread the ball links onto
each end of the pushrods and secure to the servo arm and control horn with
the 2 mm hardware as shown in the picture. Use the longest arm provided
with your servo.
6. Repeat this process for the other wing half.
7. Locate the carbon fiber main landing gear, 2 axles, 2 washers, 2 locking
nuts, 2 wheels, 2 wheel collars and the 2 wheel pants from the hardware
package. Place the threaded portion of the axle through the hole in the
carbon gear, slide a washer over the threaded portion and screw the lock nut
onto the axle, but do not tighten completely. Place the wheel onto the axle and
secure with a wheel collar. There is a slot pre-cut in the wheel pant to allow
it to fit over the axle. Slide the wheel pant into position over the axle and
tighten the nut on the axle, taking care to make sure the wheel pant is
positioned properly. Repeat this process for the remaining wheel and wheel
pant. Again this is probably better explained in the following series of
pictures
.
7