3DLabPrint Focke-Wulf Ta 152 C Podręcznik użytkownika - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zabawka 3DLabPrint Focke-Wulf Ta 152 C. 3DLabPrint Focke-Wulf Ta 152 C 9 stron. Fully 3d printable upgrade to short wing
Drukuj stronęGeneral specifications (HP setup):
Wingspan:
Lenght:
Height:
Wing area:
Wing loading:
Center of gravity:
Airfoil:
Print weight:
Print weight of hybrid version:
Empty weight (w/o battery):
Takeoff weight (6s 1500 lipo):
Max takeoff weight:
Never exceed speed, VNE:
Design maneuvering speed, VA:
Stall speed, VS:
Recommended setups
Motor:
EMAX MT 3510 600KV (for 6S setup)
DYS D4215 650KV (for 6S setup)
AX-4008Q 620KV (for 6S setup, motor is discontinued
ESC:
YEP 40A/6S
Propeller:
two blade APC electro 9 x 5,5 or Aeronaut CAM Carbon Light 9 x 6
Battery:
Li-Pol 1500-1800mAh 6S1P Battery Pack
printed PET motor mount with alluminium cross mount
Performance measurement
Max speed VH (level flight):
Rate of climb:
Flight time (6s 1700mAh/full):
... print your plane | www.3DLabPrint.com
960 mm / 37.8 inch
870 mm / 33.9 inch
178 mm / 6.95 inch
18 dm2 / 1.93 square foot
46 g/dm2 / 15.3 oz/square foot
60 mm / 2.34 inch
from leading edge
LHK508 modified by 3DLabPrint
624 g / 22.01 oz
490 g / 17.31 oz
680-890 g / 24-31 oz
810-1190 g / 28-42 oz
1300 g / 46 oz
150 km/h / 93 mph
100 km/h / 62 mph
30 km/h / 18.6 mph
- use it from your old planes)
or similar
105 km/h – 56.7kn – 65.2mph with APC 11x5,5
20 m/s (5 373 ft/min) with APC 11x5,5
7:30 with APC 10x5,5
page
3