Alto 40C/CA Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odkurzacz Alto 40C/CA. Alto 40C/CA 16 stron.

3.2 Starting-up

Turn start button on control panel to position I.

NOTE: Machines with automatic start/stop - 40CA

When the spray handle is released, the machine will automatically stop after approximately 10 sec.

The machine can be restarted just by activating the spray handle.

Only 40C: If the motor protection system engages or mains power has been disconnected, the machine

should be restarted in position - O -.

Activate the high pressure washer by releasing the trigger of the spray handle (1). When starting up the

machine the pressure may be unsteady because of air in the pump system. After a short time the air has

escaped from the system and the pressure will become steady. Never allow the machine to operate for

more than 10 min. upon release of the trigger (5 min. at most at 60°C inlet water). When the cleaner is not

in use, secure the spray handle by turning the safety knob (2) into pos. 0.

The spray lance features 2 nozzles, a high pressure nozzle and a low pressure nozzle. When the pressure

reducing valve (1) is completely closed (turned clockwise - B), only the high pressure nozzle is used - high

pressure mode. When the pressure reducing valve is quite open (turned counter clockwise - A) both

spray lances are used - low pressure mode / addition of detergents. The pressure may be regulated

between these positions.

Operating instructions

Turn to position I

Always hold the spray lance with both

hands!

Always lock the spray handle when the

cleaner is not in operation.

10 min. at most by released trigger.

(5 min. at most at 60°C inlet water).

Turn pressure reducing valve:

Clockwise (B): high pressure

Counter clockwise (A): low pressure /

addition of detergents