Alto 40C/CA Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odkurzacz Alto 40C/CA. Alto 40C/CA 16 stron.

3.5 End of operation

Turn start button on control panel to position O. Unplug.

Shut off the water supply and activate the spray handle.

Dismount the high pressure hose and the water inlet hose.

Only 40C: If the motor protection system engages, the machine should be restarted in position O.

NOTE: Machines with automatic start/stop - 40CA

When the spray handle is released, the machine will automatically stop after approximately 10 sec.

The machine can be restarted just by activating the spray handle.

When transporting the machine, lifting by crane should be undertaken; lift by both handles using a lifting

strap. When lifting by hand - use the handles and under the edge of the fender.

3.7 Storage

Prior to storing the machine should be completely emptied of water as follows: Detach the inlet hose and

the high pressure hose and start the machine. Let the machine run for approximately 3 minutes until all

water has run out of the pump system.

If the room is not frost-free the machine should be protected with an anti-freeze solution.

Operating instructions

Turn to position O

Danger of scalding! Never dismount

the high pressure hose or the water inlet

hose while the machine is in operation.

Disconnect the cleaner, shut off the

water supply and activate the spray

handle before dismounting the high

pressure hose or the water inlet hose.

Lifting points: handle and under the edge

of fender

Frost-free room or anti-freeze solution