3Doodler Flow Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Drukarki 3D 3Doodler Flow. 3Doodler Flow 9 stron.

Drukuj stronę

My pen won't

turn on (the LED

light isn't on)

Plastic won't stick

to the paper, or is

curling up around

the nozzle

Plastic is not

extruding from my

3Doodler Flow

Plastic is leaking

from around the

nozzle

Plastic won't stop

extruding

11/2023

Is the USB-C cord connected

into the power adapter?

Stop extruding and start again using the following

instructions:

Push the nozzle down onto the paper, and then resume

extruding plastic.

Drag the tip of the pen along the paper or surface in a

continuous unbroken line as if you were writing with a

pencil.

Keep your movement slow and steady. The plastic should

hold to the paper and not curl up around the nozzle.

3A.

The plastic is not engaging properly with the drive gear:

With the pen extruding, gently push on the filament spool until

you feel it being pulled through the drive gear on its own.

If the above does not work, reverse the plastic from the pen. (See

Section

4) Snip the ends, flat, avoiding any angles, set the pen to

extrude, reinsert the filament, and try again. If the plastic is too

short to be reversed from the back of the pen, move to 3B.

3B.

The plastic is too short to be removed from the pen:

Tool included

While the pen is on and the nozzle is

hot, unscrew the nozzle using the back

end of the included tool.

The nozzle may loosen with continued usage (or in

transit). While the pen is hot

Light is on), gently turn the nozzle clockwise to tighten

it using the included tool. Stop tightening once you first

feel resistance so as to avoid over-tightening the nozzle

and breaking it.

5A.

Click either speed button once.

5B.

If the pen keeps extruding, disconnect it from the

power supply and then plug it in and try again.

NOTE:

If you have a spare power adapter please use it to test

your 3Doodler Flow. You will need a DC 5V2A power

supply with a USB-C port. This will help determine if

the problem is with your 3D pen or with the included

power adapter. Please make sure the power adapter is

20 watts or lower. This pen will not run on USB-C smart

power adapters.

BLUE or GREEN

Light

Double click either speed button to

set the pen into reverse. Insert the tool

through the front end of the pen and

gently push any excess plastic through

the back of the pen

(BLUE

GREEN

LED

SECTION 3: TROUBLESHOOTING

Tool included