3DUpFitters Taz6 Enclosure Kit Instrukcja instalacji - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Drukarki 3D 3DUpFitters Taz6 Enclosure Kit. 3DUpFitters Taz6 Enclosure Kit 15 stron.

Attach the right side to the connectors on the back and front. The three sides should

make a U shape, as shown below.

7. Attach Feet

The feet raise the enclosure from the

surface slightly, making it ﬁt perfectly

around the Taz6. If you've also purchased

an air ﬁlter, it helps bring in air from the

outside to run through the ﬁlter.

8. Attach Top

Place the top on the existing three sides

and attach it to the corner and mid-

panel connectors. The enclosure will

now look like the picture to the right.

Note that on models with a 6mm front

and 3mm sides, the top has a front

and a back! The holes on the front are

positioned so that the top ﬁts over the

front section with the door.