3DUpFitters Taz6 Enclosure Kit Instrukcja instalacji - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Drukarki 3D 3DUpFitters Taz6 Enclosure Kit. 3DUpFitters Taz6 Enclosure Kit 15 stron.

8. Attach Left Sides

First, attach the left-side top connector as shown below.

The left panel is split into two to ﬁt around the electronics without cracking. The front left panel has a slit

to ﬁt around the knob, while the rear left panel has a cutout to accommodate the electronics case's

back.

Slide the enclosure around the Taz6 so that it is approximately in the center.

Place the left-front panel around the electronic enclosure to get a feel for how it ﬁts snugly against the

case, and then move the enclosure into position to line up with the holes.

Attach the front left panel with screws, reaching through the front door to reach the nuts.

Repeat the process with the rear-left panel.