ESI EPPA2-KIT Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Stojaki i stojaki ESI EPPA2-KIT. ESI EPPA2-KIT 12 stron. Dual monitor arm conversion

MONITOR REMOVAL

Disconnect and Remove the Monitor from EPAA Single Arm System

The monitor arm and its base components are reused when converting to a dual arm system. The first step

in this process is removing the monitor from the monitor arm.

Remove Cable Covers

The cable covers on the underside of the monitor arm must be

removed before removing the monitor.

• Slightly pull apart the ends of the upper cable cover to

remove it from mounting holes on the monitor arm.

• Slide the lower cable cover up toward the

monitor to remove it. Do not attempt

to snap it off.

• Unplug the monitor cable and

power cord.

Remove Monitor

• Remove the bottom two screws securing the monitor to the VESA mount.

• While supporting the monitor, loosen but do not remove the top two screws.

• Lift off the monitor and place it face down on a soft, flat surface.

NOTE: If the inner holes on the VESA mount were used to attach the monitor, after loosening the top two

screws, lift the monitor and pull the screws through the large part of the keyhole opening.

M4x12 or

M5x12

Loosen

Screws

EPPA2-KIT

Lift Off

Monitor