ClearOne WS880 Skrócona instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla System mikrofonowy ClearOne WS880. ClearOne WS880 15 stron.
Drukuj stronę
WS800 and Dialog20 Remote Software (new):
1)
Click to Edit the
channel's parameters.
ClearOne Remote provides the following functions:
1. File: File menu allows the current receiver settings to be saved to a file on your computer or for a previously
saved file on your computer to be recalled to the receiver.
2. Settings:
A. Phantom Power: Turn antenna phantom power on or off. Default = ON.
B. Redundancy: Set adjacent pairs of receivers to redundancy mode. Default = OFF.
C. Headphone Mode: Toggles the mixed output jack from headphone mode to a balanced line output.
Default = Balanced line output.
D. Ethernet Settings: If using Ethernet, assign the proper IP address to the receiver or, enable DHCP .
Default = DHCP enabled.
E. Receiver OLED Dimming: Set the Receiver OLED Display Mode and timer value. Default = Bright when
transmitter is on. Times out after 1 minute.
F. Print Current Settings: Opens print dialog box.
G. Set Receiver Name: label each receiver with a unique name using up to 26 characters.
3. RF Scan - RF Plot: Shows the RF strength of each antenna in a ClearOne system and shows if there is out-
side interference (see Pg. 5).
4. Presets: saves settings to receiver memory or recalls settings from receiver memory. Load "PRESET 1" for
the factory default settings.
5. GPIO: Assign contact closure functions and setup for RS232 control. Default = RS232 enabled.
6. Alerts: Send alerts to authorized personal when preventive maintenance is required of if there is a fault.
Default = none.
7. Help:
A. Tutorials: Setting parameters, Antenna Application Guide, Channel Frequency Assignments, etc.
B. About: Shows vital statistics for each component of the system.
Default Transmitter Preamp Gain Settings:
Transmitter + Last 4 digits of serial Number
4
2)
Select the new parameter values and
click "Apply" and
BLT XXXX
HH XXXX
PDM XXXX
BDM XXXX
Close.
Default Transmitter Preamp Gain
+10 dB
H18 = 0dB / H13 & H15 = +20dB
+10dB
+20dB
3)
The "Need To Sync" alert is lit. Sync the transmitter
to confirm the selected parameters.
Key:
BLT = Beltpack
HH = Handheld Mic
PDM = Gooseneck / Podium Mic
BDM = Tabletop / Boundary Mic