ClearOne WS880 Skrócona instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla System mikrofonowy ClearOne WS880. ClearOne WS880 15 stron.

RF Scan and choosing transmitter channels:

1. To run an RF Scan, open the WS800 and Dialog20 Remote Software or the ClearOne WS800 Remote

Software (older version). Screen shots from the older and newer software are shown below.

2. Turn off all of the transmitters.

3. Select "RF Scan" from the tab menu.

4. Press "Start Scan" to begin the scan. Let the scan run for 3 to 5 minutes.

5. Red lines indicate potential interference.

6. Take note of the RF channels with the least amount of interference. A channel with more than -75 dB RF Level

should be avoided.

7. Set the RF channel of the transmitter based on the results of the RF Scan.

8. To set the channel of the transmitter, stop the scan and close the RF Scan Window.

9. Click "Edit" on the slot that you wish to change the channel.

10. An Edit Parameter Window will pop up. Change the channel to the clear channel noted earlier and click

"Apply" to save the changes (On the old GUI click "Send changes to receiver and close").

11. Sync the transmitter (see Pg. 6).

WS800 and Dialog20 Remote Software (new)

Clearone WS800 Remote Software (old)

Edit Parameter Window