ClearSpan PB00566R4 Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Namiot ClearSpan PB00566R4. ClearSpan PB00566R4 18 stron. Freestanding “hut” style model 14' wide x 14' high x 36' long
Drukuj stronęStep 7: Slide a 1.66" band clamp over each end of the rafter and up the rafter a few feet. These will
be used to secure the struts.
Step 8: Slide another set of Purlin End Clamps onto each end of the rafter. These will be be used
at the lower ends of the rafter and will "trap" the band clamps so they canʼt fall off. The clamp
should be about 2" away from the end of the rafter to leave room for the "T" connector which
will be added later. You should now have a total of 5 sets of end clamps on your rafter.
Step 9: Repeat the steps above to assemble the other end rafter exactly like the one you just made.
Step 10: On all inside rafters, install Purlin Cross Clamps at the same locations where you installed
end clamps on the end rafters. Leave the screws loose so you can slide in the purlins later on.
This model has 5 clamps per rafter.
Tip: On the sides of the rafter, position the top strap of the cross clamp assembly so it rests on
the Tek screw. This will help prevent the clamp from slipping if the purlin supports any weight.
Lower Position (with purlin installed)
Typical Cross Clamp Assembly
Page 9