Acoustical Systems SMARTractor Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Acoustical Systems SMARTractor. Acoustical Systems SMARTractor 8 stron. Universal high-precision triangular positioning & alignment instrument for optimized analog phono tonearm alignment & true one-point cartridge set-up

Drukuj stronę

Setting up the

SMARTractor

20 mm spindle ring

and 12 mm insert

Step 1

The SMARTractor is already pre-assembled

with the 20 mm POM spindle ring (part of the uni-

versal 3-part spindle-adapter) sitting in the center

of the SMARTractor.

First place the SMARTractor - with the 20 mm

POM spindle ring - on the spindle.

Step 2

Now take the

mm (tall) or 6 mm (short

and wide collar) spindle ring insert**

SLOWLY and CAREFULLY place it on the top

of the spindle and ever so slightly press down.

IMPORTANT - be carefull!

** 12 mm or 6 mm spindle insert ??

The 12 mm (tall) insert will work with small diameter spindles (smaller

then 7.15 mm diameter). The 6 mm (wide) insert will work with 7.2 and

wider diameter.

Do not press down the spindle adapter too hard or too deep. On some

spindle it will only be 2-3 mm or less. If you press too hard, you will

have a very hard time getting the white 20 mm POM ring off your

spindle again.

The 12 mm and / or 6 mm spindle adapter insert allows the precise

centering of the SMARTractor on a wide range of spindle diameters.

Remember - Please be careful and do not use any excessive force.

Pushing down realy hard creates a VERY tight lock which you will

have big problems loosening up again.

Measuring P2S

Step 3

If you want to measure the arm mounting

distance or P2S, rotate the central block to the

UNI P2S

fixing the positioning arm in the black POM

block.

The engraved line on the center piece will meet

the line at

Slide the central assembly back or forth so that

the hole for the thumbscrew is aligned with the

. Now

locking thread for the selected curve - there is

only 1 possible thread hole to move to in each

position.

Fix the assembly in place by re-installing and

tightening the thumbscrew. The thumbscrew need

only be very snug by hand tension.

position, loosen the locking screw

"UNI

P2S".

UNI P2S