ClearView WiFi-2MP-BL100 Podręcznik Faq - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik Faq dla Kamera bezpieczeństwa ClearView WiFi-2MP-BL100. ClearView WiFi-2MP-BL100 12 stron. Wireless bullet camera

Drukuj stronę

1 Network Problem

1.1 My WIFI-2MP-BL100 is off line from time to time.

Solution 1: Check if the network environment is good and the network cable hole plug of WIFI-2MP-

BL100 end is loose.

Solution 2: Check if there is IP conflict.

Solution 3: Check if the device is under normal power supply.

Solution 4: Check if the device upgraded to a wrong program.

1.2 What if network upgrade failed?

Solution 1: Log in again to check if upgrade is successful, because sometimes the progress bar

doesn't show feedback in time due to the network environment.

Solution 2: Check if the network environment is normal, and there is disconnection or power failure

during upgrade.

Solution 3: Check if the program and the device are matched.

Solution 4: Re-upgrade through 3800 port of config tool (3800 needs to upgrade matched program).

1.3 I can use "Ping" to test that the WIFI-2MP-BL100 is on line after

upgrade, but fail to log in.

Possible reason: Check if the WEB port was modified.

Solution 1: Reset the device and log in again.

Solution 2: Re-upgrade through 3800 port of config tool (3800 needs to upgrade matched program).

1.4 There is no code stream when I log in and the network program restarts

constantly after upgrade.

Solution 1: Check if there is IP conflict or network disconnection.

Solution 2: Check if the device is under normal power supply.

Solution 3: Check if each connection line is loose inside the device after disassembling the camera.