ClearView WiFi-2MP-BL100 Podręcznik Faq - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik Faq dla Kamera bezpieczeństwa ClearView WiFi-2MP-BL100. ClearView WiFi-2MP-BL100 12 stron. Wireless bullet camera

Drukuj stronę

2 Image problem

2.1 IR effect is bad.

Possible reason 1: Users didn't use specified power supply, and failed to enable all the IR lights.

Possible reason 2: The object is so far that it is out of the range of IR light.

Possible reason 3: IR-CUT is set as color mode, which caused the front-end sensor to fail to sense IR

light.

Possible reason 4: When you use the device on the table (especially rough surface), the IR light will

shoot back to the lens, which will cause bad IR effect and white picture. At this

moment, you should adjust the elevation angle of the lens or place the device on

the edge.

2.2 The device failed to record or snapshot.

Possible reason: "Snapshot Schedule" is set wrongly; storage path is not correct; "Record Mode" is set

as off.

Solution 1: Set "Record Schedule", "Snapshot Schedule" in the WEB interface; please refer to the

<WIFI-2MP-BL100 WEB Operation Manual> for more details.

Solution 2: Check if the "Destination" enable in the WEB interface is checked.

Solution 3: Check if the connection of SD and FTP of video and snapshot storage is normal, try to

connect FTP to the computer.

Solution 4: Set "Record Mode" as manual or auto in the WEB interface.

2.3 Black edge appears in the image after upgrade.

Solution 1: Eliminate WIFI-2MP-BL100 configuration or restore factory default after upgrading program.

Solution 2: Upgraded program is not corresponding to the WIFI-2MP-BL100 model, re-upgrade correct

program.

2.4 Cross stripe or diagonal stripe appears in the image of WIFI-2MP-

BL100.

Possible reason 1: Bad connection for the video cable.