Artic AR-MSCOPE-FO-400X-T Skrócona instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Mikroskop Artic AR-MSCOPE-FO-400X-T. Artic AR-MSCOPE-FO-400X-T 4 stron. Fiber microscope
Drukuj stronęAR MSCOPE FO 200X//400X T
2. OPERATION
In this manual, we will explain general use of the Fiber Microscope. However, it is important
toreadthespecific termination instructions published by the manufacturer of the connector you
are using. Thiswill ensure proper termination. Also, be sure you have read the User Safety
Warning and fully understandthatdirect eye contact with laser light and magnified laser light
should be avoided.
1. Begin by loading the polished connector into the adapter. If you have purchased our
Universal Adapter,simply slide the connector ferrule(2.5mm)into the hole until you feel it hit a
stop (see figure3).it mayrequirea little pressure to get it started as our Universal adapter is
equipped with a no-slip gripping mechanism.it isimportant to slide the connector ferrule all the
way to the stop. This will minimize any refocusingthat needsto be done when changing from
one connector to the next. if you have purchased one of thededicatedadapters, insert the
connector just as you would into a patch bay or mated connector.
2. Now turn the light on.The light operates by pressing and holding the light Switch in .You
cantell if thelight is on by checking the "Backlight Window"(see figure1). If you see light through
this window, youareready to work.
3. Once the connector is loaded and the light is on, hold the eyepiece up to your eye and
beginfocusing. Unlike many instruments of this type, the Fiber Microscope is always centered so
there is no alignment tobe done. Grip the focusing adjustment(brass wheel with rubber grip,see
figure#1) and turn it to. focus the image.The first time you use the microscope, it to focus the
image.The first time youusethemicroscope, it may take a little longer to find the image. Once
you find the image, very little re-focusingisnecessary if the connector is properly loaded.
4. Once you can visualize the connector ferrule, you can evaluate it for polish quality,cleave
quality, andcleanliness optionally, you can hold the opposite end of a cable to the Backlight
windowto give furthercontrast to the core. Check with the manufacturer of your connector for
further instructions.
3. CHANGING THE LAMP
1. This microscope utilizes a white LED light source. The LED has a stated lamp life of over 100,
000hours.Therefore, you should never have to change the lamp. if you have problems with
illumination, please call your sales person to arrange for repair.
[email protected] | www.articlatam.com
3 de 4