akkuteam VAS 5581 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe akkuteam VAS 5581. akkuteam VAS 5581 17 stron. Hv measurement adapter

Operating Instructions

HV Measurement Adapter VAS 5581

After being prompted by the guided trouble-shooting procedure, add

terminal 15 and terminal 30 with the F1 and F2 keys. The switching

status of the terminals is indicated by the green LEDs next to the keys.

When the LED is lit, the associated terminal carries voltage (12 Volts).

The electricity is connected to the BMS via the diagnostics port and via

the adapter cable.

Select the CAN termination impedance indicated by the guided trouble-

shooting procedure by repeatedly pressing the CAN-R select (F3) key.

The respectively selected impedance value is indicated by the yellow

LED on the selection row. The measurement adapter is now ready for

communication. Now follow the instructions from the guided trouble-

shooting procedure.

When prompted by the guided trouble-shooting procedure to perform

the "Close Connection" function, press and hold the F4 key on the

measurement adapter for 5 seconds until the blinking "ready" status

LED lights up steadily. Now press the F4 key once again within an

additional 5 seconds, therefore triggering the "Close Connection"

function. This activates the "Close Connection" function. This supplies

terminal 30C with on-board power and the pilot line is closed.

The "Closed" LED now also lights up as a confirmation and the power

supply to terminal 30C drops off.

Pressing the F4 key once again resets the function and the connection is

reopened. This causes the function LEDs to go dark.

The device is shut down by pressing the green On button once.

www.akkuteam.de

4.8 Firmware update

NOTE! When a firmware update is made available for

download, the download contains separate operating

instructions for installing the update.

The firmware status of the measurement adapter can be updated.

In order to upload an update revision of the firmware/software,

connect the VAS 5581 to a Windows PC via its USB port. Each new

firmware revision comes with its own detailed instructions.

The firmware revision is published by the sales organization or can be

obtained as a download from akkuteam.

www.akkuteam.de

1 VAS 5581 Measurement Adapter

1 VAS 5581-1 Adapter cable

1 Power supply - 18 Volt 4.75 A (90-240 VAC 50/60 Hz)

1 Power cable - EU

1 Operating manual

1 Carrying case

V 1.0