djpower WP-1S Podręcznik - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik dla Maszyna do mgły djpower WP-1S. djpower WP-1S 12 stron. Bubble fog machine

Drukuj stronę
3
Wind Output
Bubble cleaning
4

6 TECHNICAL INFORMATION

Maintenance

6 6 . . 1 1
After each time use of the bubble fog machine, it is necessary to clean the fog head with clean water in time
to prevent the residual bubble liquid on the fog head from solidifying and gluing, which will cause it to fail to
be used normally next time!
Do not allow the WP-1S to become clogged due to the sticky bubble fluid. Cleaning and maintenance are
necessary.
The recommended cleaning procedure is as follows.
1) Unplug the product from power.
2) Empty bubble fluid from the machine.
3) Add water to the bubble fluid tank.
4) Connect the product to power and allow it to warm up. Run the Cleaning Mode through Menu or DMX.
Thoroughly rinse the Bubble fluid reservoir.
5) Run the product in a well-ventilated area. Do not allow the pump to run dry.
6) Excessive dust, fluid residue and dirt will degrade performance and cause overheating. Remove dust
from air vents with air compressor, vacuum or soft brush. The casing could be cleaned by the damp cloth.
7) Restore the hoses and cap. Store the unit until next use.
The default cleaning time is 1 minute. Without turning of the cleaning mode manually, it will shut of
automatically after 1 minute.
Test-run your DJPOWER® WP-1S on a monthly basis to achieve the best performance.
7 7 S S T T O O R R A A G G E E
7 7 . . 1 1
M M a a c c h h i i n n e e S S t t o o r r a a g g e e
Before storing the machine, clean it as described in the cleaning procedure above; however, only follow
steps 1 through 5. Do not refill the tank with fog fluid if storing the machine. Empty both the bubble and
haze fluid tank. Cleaning the system prior to storage will help prevent any particles from condensing inside
the pump or heater while not in use.
< 8 >
10
011-255
000-010
11-100
101-200
201-255
000-010
mode
011-255
Fog volume,low to high
OFF
Fan speed Low
Fan speed Middle
Fan speed High
OFF
Bubble cleaning mode ON, overriding other functions