djpower WP-1S Podręcznik - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik dla Maszyna do mgły djpower WP-1S. djpower WP-1S 12 stron. Bubble fog machine

4 4 . . 3 3

M M o o u u n n t t i i n n g g

Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes.

4 4 . . 3 3 . . 1 1

O O r r i i e e n n t t a a t t i i o o n n

For safety reasons, we do not recommend mounting the product in any capacity. Operate the product while

it is on the ground only, and make sure there is adequate room for ventilation, configuration, and

maintenance.

Do not mix bubble

fluid and fog fluid.

4 4 . . 3 3 . . 2 2

R R i i g g g g i i n n g g

DJPOWER recommends using the following general guidelines when mounting this product.

•

Before deciding on a location for the product, make sure there is easy access to the product for

maintenance and programming purposes.

•

Make sure that the structure or surface onto which you are mounting the product can support the

product's weight (see the Technical Specifications).

•

When mounting the product on the floor, make sure that the product and cables are away from people

and vehicles.

5 5 O O P P E E R R A A T T I I O O N N

5 5 . . 1 1

P P r r e e p p a a r r i i n n g g f f o o r r O O p p e e r r a a t t i i o o n n

•

After checking that all the parts are intact and complete, position the machine on flat.

•

Withdraw the fluid tank from its compartment and remove its cap.

•

Verify that the plastic hoses attached to the cap are in place and in good condition without bending or

warp.

•

Always connect the product to a grounded circuit. Before power on, make sure it is connected with the

rated voltage.

•

Turn on the machine, and"U1.0"shows on the Digital display tube and then show " HEAT" immediately

during the heating-up process. After approx.4 minutes, the Digital display tube changes to "ADDR" when

the machine is ready to output.

5 5 . . 2 2

O O n n - - d d e e v v i i c c e e C C o o n n t t r r o o l l P P a a n n e e l l

To access the control panel functions, disconnect the DMX signal, and use the four buttons located

underneath the Digital display tube.

< 6 >