Artison Sketch LCR DualMono MK 2 Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Głośniki Artison Sketch LCR DualMono MK 2. Artison Sketch LCR DualMono MK 2 4 stron.
Również dla Artison Sketch LCR DualMono MK 2: Instrukcja instalacji (16 strony), Skrócona instrukcja obsługi (4 strony), Skrócona instrukcja obsługi (4 strony)

Stage Tweeter (On/Off Switch)

The Stage Tweeter on the rear of the speaker enclosure widens the left and right channel separation by directing out-of-phase high frequencies

(6 kHz and higher) against the adjacent wall. The installation will determine whether the stage tweeter switch should be ON/UP or OFF/DOWN.

Set the stage tweeter before mounting speaker into the wall mount bracket.

OFF

Installations where the speakers and TV are flush mounted into recessed cabinetry or when mounted flush into the wall using the in-

wall mount kit (LCRDM-IW-KIT).

All other installations.

Install Main LCR Brackets

Each LCRDM MK2 speaker includes a mounting bracket. These brackets are

mounted to each speaker for shipment. Follow instructions below to mount to

an existing wall or similar.

IMPORTANT! DO NOT place speakers face down as this can permanently

damage the individual drivers.

1. Remove thumbscrews from top and bottom of speakers and remove

mounting bracket.

2. Position the bracket on the wall (either left or right of TV) and with a level,

ensure bracket is plumb.

3. With a pencil, mark the two mounting slots. See image to the right.

4. If there is a sub wall to screw to, secure the bracket using #6 self tapping

screws (not included). If there is no sub wall, sturdy drywall anchors that

can support at least 20 lbs (9.07 kg) can be used.

5. Repeat steps 1 - 4 and mount the second speaker bracket at the opposite

side of the TV.

NOTE: The LCR brackets along with the Universal Mounting Brackets (UMB-xx)

can also be used to mount the LCR speakers directly to the side of a TV.

For installation instructions, refer to the documentation included with

the Universal Mounting Brackets.

Mount Speakers

With the speakers wired and Stage Tweeter ON/OFF switch set, mount the speaker enclosure into the wall mount brackets installed in the Install

Main LCR Brackets section above.

Slide the right channel speaker enclosure into the wall mount bracket with the stage tweeter facing away from the TV.

Secure the speaker to the bracket using the thumbscrews removed in the previous section.

Repeat steps 1 and 2 and mount the left channel speaker into the wall mount bracket. When complete, the installation will look like the

example below.

Masterpiece LCR Dual Center MK2 Installation Guide | 009-1625-02

Speakers are secured to

brackets using thumbscrews

Flat Panel TV

Mounted to Wall

Secure bracket to wall

using #6 x 1 ½ inch screws

and heavy duty wall anchors

45 Perseverance Way, Hyannis, MA 02601

www.savant.com/artisonspeakers

| 508.683.2500