Artison Sketch LCR DualMono MK 2 Kurulum Kılavuzu - Sayfa 3
Konuşmacılar Artison Sketch LCR DualMono MK 2 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Artison Sketch LCR DualMono MK 2 4 sayfaları.
Ayrıca Artison Sketch LCR DualMono MK 2 için: Kurulum Kılavuzu (16 sayfalar), Hızlı Referans Kılavuzu (4 sayfalar), Hızlı Referans Kılavuzu (4 sayfalar)
Sayfayı Yazdır
Stage Tweeter (On/Off Switch)
The Stage Tweeter on the rear of the speaker enclosure widens the left and right channel separation by directing out-of-phase high frequencies
(6 kHz and higher) against the adjacent wall. The installation will determine whether the stage tweeter switch should be ON/UP or OFF/DOWN.
Set the stage tweeter before mounting speaker into the wall mount bracket.
OFF
Installations where the speakers and TV are flush mounted into recessed cabinetry or when mounted flush into the wall using the in-
wall mount kit (LCRDM-IW-KIT).
ON
All other installations.
Install Main LCR Brackets
Each LCRDM MK2 speaker includes a mounting bracket. These brackets are
mounted to each speaker for shipment. Follow instructions below to mount to
an existing wall or similar.
IMPORTANT! DO NOT place speakers face down as this can permanently
damage the individual drivers.
1. Remove thumbscrews from top and bottom of speakers and remove
mounting bracket.
2. Position the bracket on the wall (either left or right of TV) and with a level,
ensure bracket is plumb.
3. With a pencil, mark the two mounting slots. See image to the right.
4. If there is a sub wall to screw to, secure the bracket using #6 self tapping
screws (not included). If there is no sub wall, sturdy drywall anchors that
can support at least 20 lbs (9.07 kg) can be used.
5. Repeat steps 1 - 4 and mount the second speaker bracket at the opposite
side of the TV.
NOTE: The LCR brackets along with the Universal Mounting Brackets (UMB-xx)
can also be used to mount the LCR speakers directly to the side of a TV.
For installation instructions, refer to the documentation included with
the Universal Mounting Brackets.
Mount Speakers
With the speakers wired and Stage Tweeter ON/OFF switch set, mount the speaker enclosure into the wall mount brackets installed in the Install
Main LCR Brackets section above.
1.
Slide the right channel speaker enclosure into the wall mount bracket with the stage tweeter facing away from the TV.
2.
Secure the speaker to the bracket using the thumbscrews removed in the previous section.
3.
Repeat steps 1 and 2 and mount the left channel speaker into the wall mount bracket. When complete, the installation will look like the
example below.
Masterpiece LCR Dual Center MK2 Installation Guide | 009-1625-02
Copyright 2020 Savant Systems, Inc | 200821
Speakers are secured to
brackets using thumbscrews
Flat Panel TV
Mounted to Wall
3
of
4
Secure bracket to wall
using #6 x 1 ½ inch screws
and heavy duty wall anchors
45 Perseverance Way, Hyannis, MA 02601
www.savant.com/artisonspeakers
| 508.683.2500