DK2 Power OPC506 Instrukcja montażu - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Chipper DK2 Power OPC506. DK2 Power OPC506 14 stron. 4 and 6 inch commercial chipper

STEP 7: INSTALL FEED CHUTE

1. Install the feed chute on the 2 hinges. To seat the hinge pins

for the first time a rubber mallet may be used to tap the

pins into the hinges. These are tight fitting to reduce

vibration noise.

2. Close the Chute and latch it.

3. Plug the safety key shut off wire connectors together.

CONNECT WIRING CONNECTORS