Artiste E1 Podręcznik użytkownika - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Słuchawki Artiste E1. Artiste E1 10 stron. 2.4ghz wireless induction neck-loop headphone

SET UP THE NECK LOOP RECEIVER

■

Installation and charging the battery

Insert a battery into the Receiver with correct Polarity.(See Below Fig. A)

Charge the battery for about 3 hours before first use. Switch off the Receiver (position OFF).

Place the Receiver into the charging cradle of the Transmitter. The charging process starts

automatically. The battery LED indicator will be red and will turn to green when the battery is

fully charged. This takes about 3 hours. (See Below Fig. B)

Insert the spare battery into the base as indicated in the drawing. The LED will remain red and

turn green when it is fully charged after about 3 hours. (See Below Fig. C)



A fully charged battery provides about 6 hours of listening enjoyment.



To conserve battery power, the receiver automatically shuts off if no signal is detected

for a period of approx. 5 minutes or when the audio signal level is too low. However, if

the signal returns to an acceptable level, the Transmitter will automatically turn ON

again.

WARNING:

Never attempt to recharge conventional dry cells.

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine,

fire or the like

Never use another type of battery or non-rechargeable batteries to replace the rechargeable batteries

supplied.

When the Receiver is not in use, move the switch to the OFF position to avoid damaging the battery..

The batteries must always be fully charged before first use. An initial 3 hours charge is required to