Artiste E1 사용자 설명서 - 페이지 7

{카테고리_이름} Artiste E1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Artiste E1 10 페이지. 2.4ghz wireless induction neck-loop headphone

SET UP THE NECK LOOP RECEIVER

■

Installation and charging the battery

Insert a battery into the Receiver with correct Polarity.(See Below Fig. A)

Charge the battery for about 3 hours before first use. Switch off the Receiver (position OFF).

Place the Receiver into the charging cradle of the Transmitter. The charging process starts

automatically. The battery LED indicator will be red and will turn to green when the battery is

fully charged. This takes about 3 hours. (See Below Fig. B)

Insert the spare battery into the base as indicated in the drawing. The LED will remain red and

turn green when it is fully charged after about 3 hours. (See Below Fig. C)



A fully charged battery provides about 6 hours of listening enjoyment.



To conserve battery power, the receiver automatically shuts off if no signal is detected

for a period of approx. 5 minutes or when the audio signal level is too low. However, if

the signal returns to an acceptable level, the Transmitter will automatically turn ON

again.

WARNING:

Never attempt to recharge conventional dry cells.

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine,

fire or the like

Never use another type of battery or non-rechargeable batteries to replace the rechargeable batteries

supplied.

When the Receiver is not in use, move the switch to the OFF position to avoid damaging the battery..

The batteries must always be fully charged before first use. An initial 3 hours charge is required to