Artiste E1 사용자 설명서 - 페이지 10

{카테고리_이름} Artiste E1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Artiste E1 10 페이지. 2.4ghz wireless induction neck-loop headphone

Try using a different connection RCA, OPTICAL or HEADPHONE.

Distortion

The charge level of the battery inside the Receiver may be too low. Recharge the battery or

replace them with a fully charged battery.

The Receiver may be too far away from the Transmitter. Move closer to it.

The audio signal input level may be too low. Increase the volume from the audio source.

The audio signal input level may be too high, lower the volume from the audio source.

In case the Neck Loop Receiver cannot be linked with the Transmitter. Please follow the

following procedure for Pairing:

Turn OFF the power of the Transmitter.

Turn ON the Receiver.

Press and Hold the MIC Button for about 5 seconds, the Green LED flash quickly in the

Receiver, then turn ON the power of the Transmitter.

The Receiver and the Transmitter is then Paired automatically, and the Green LED on the

Receiver lights steadily.

One Transmitter can be connected to several Receivers as above.

TECHNICAL SPECIFICATIONS

Transmission mode: Digital Hopping System

Carrier frequency: 2.4GHz ISM BAND l

Operating voltage: Transmitter 5V

Receiver 3.7 V Lithium Polymer Battery

Frequency response: 20 Hz – 20 KHz

Distortion: 0.5%

Signal-to-noise ratio: 85dB

Work Time: 6 hours

Charge Time: 3 hours

Range: Up to 30 meters (open area)

MADE IN CHINA