Artiste E1 사용자 설명서 - 페이지 8

{카테고리_이름} Artiste E1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Artiste E1 10 페이지. 2.4ghz wireless induction neck-loop headphone

guarantee an acceptable service life for the rechargeable batteries. Always ensure that the Receiver

is switched to OFF position while the battery is charging.

Excessive sound pressure from earphones and headphones can cause hearing loss.

IMPORTANT:

This unit should be operated with rechargeable batteries only. When replacing the batteries or when

disposing of the unit, always comply with applicable laws relating to the disposal of batteries. Please

place them in a proper disposal container to ensure that they are eliminated safely and in an

environmentally friendly way.

OPERATION

Hearing damage due to high volume!



Before putting the Receiver ON, lower the volume setting and gradually increase the

volume to suit.



Do not continuously expose yourself to high volumes.

Switch on the audio source (TV set or audio component) that the Transmitter is connected to.

The Green LED Indicator will glow constantly.

Switch the On/Off switch on the Receiver to ON position.

The neck-loop induction cable can transmit the audio signal to the hearing aid device with "T-

Mode" for listening (Note: any earphone/headset must be pulled out from the 3.5 mm audio

Output Jack).

Earphone or Headset can be to the 3.5 mm audio Output Jack on The Receiver for direct

listening.

Adjust the tone clarity setting to achieve optimum performance.

Note: When the battery level is low, you will hear 3 beeps every minute in the Receiver. The Receiver

will be switched off automatically after 5 minutes.

■

The Microphone Button

The microphone opening at the side of the Receiver picks up the sounds of your surroundings. When

the Microphone Button is pressed ON, you will hear your surroundings louder. You can hear for

example your door bell, your telephone or your conversational partner louder when you are wearing

the Receiver.

Press the Button to switch the microphone on. The power on indicator will turn from green to red and

two short beeps are to be heard. Make sure that the microphone opening is not covered.

You can hear your surroundings and you use the receiver as an assistive listening device which helps

you hear other people better.

To switch the microphone OFF, press the Button again. The power on indicator will turn to green and

you will hear the sound from the audio source.

■

Tone clarity

You can set the Tone Clarity with the key on the Transmitter. Press and release the required key

repeatedly. The current setting will be indicated by the status of the three LED's.