Alutech Sun Shield EM3430L Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria Alutech Sun Shield EM3430L. Alutech Sun Shield EM3430L 13 stron. Retractable awning

Drukuj stronę

Mounting

Mounting on concrete wall or ceiling

The awnings must be installed at least at the height of 2.5 m on a reinforced concrete wall

or ceiling. Please ask professionals for help if you are notsure.

Make sure the wall/ceiling is plane, so that bracket seats solidly.

WARNING Three healthy adults are needed to move and install the awning.

For safe and smooth installation think about how you will be securing the awning to

the wall ahead of time.

Step 1: Chose the installation area

Ensure that you also take this drop height into account in your decision on where to install the awning.

The drop angle can still be changed after assembly. The ideal drop angle, however, has already

been set at the factory and may only be changedminimally.

The approximate total drop area of the awning varies depending on the type. We recommend that

the awning front bar has a height of at least 2.5 m when it is fullyextended.

In the event you would like to mount it above a balcony door, you should leave a space of at least 20

cm above the door frame if there is enough space available above the door frame.

Drawing 1:

Ensure that you also take this drop height into

account in your decision on where to install the

awning. The awning front bar should have a

height between 2.5 and 4 m.

Step 2: Mark drilling holes

After choosing mounting position you can mark where you need to drill holes for the brackets. Draw

ahorizontallineattheheightoftherequiredplace.Usealongtapermeasure,alevelandchalk.

We already marked where and with what width brackets need to be mounted. Measure the width

between the brackets and copy it to the line on your wall/ceiling.

Mark the corresponding places on the wall by running a marker pen through the holes at the bottom

of the brackets.

Make sure the two outer brackets are located outside of the arm stands and one is located in the

middle of the awning, see Drawing 2.

Drawing 2:

Mark where you need to drill holes for

brackets with a chalk line to ensure awning

is straight.

X+10cm