Alutech Sun Shield EM3430L Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria Alutech Sun Shield EM3430L. Alutech Sun Shield EM3430L 13 stron. Retractable awning

Drukuj stronę

Step 3: Drill holes

Use 14-mm masonry drill to drill the holes for the brackets at the appropriate marks on the wall. The

holes should be 9 cm deep in the wall and must be drilled through solid masonry or concrete. Do not

bore through mortar because this does not offer the strong enough support that is required by the

installation of awning.

Step 4: Insert anchors into wall

After drilling the holes you can insert the anchors into the wall. Remove lock nut, washer and locking

ring before you insert the anchor. Store these parts so that you can reach them easily in the next

step.

It may be necessary to drive the anchor bolts in with a wooden hammer because they do not

go in easily. Do not use a metal hammer for this purpose because this could damage the

threads on the top of thebolts.

If the bolts need to be driven into the wall with a hammer, we recommend initially placing the

nut on the screw loosely (only placing it loosely on the bolt) because this avoids damage to

the boltthreads.

Drawing 4:

Insert the anchor into the drilled hole as

shown in picture on the right

Drawing 3:

Use 14-mm masonry drill to drill 9 cm deep

holes.