DNP CX-120 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Drukarka DNP CX-120. DNP CX-120 16 stron. Direct dye sublimation printer

Operating the Printer

Initialization

Initialization operation can be understood as follows.

Initialization starts automatically when

printer door is closed.

Caution

1) Upon removing a card during a card jam

Example

2) Upon changing an ink ribbon when ink runs

out

Ink ribbon will be initialized when a different

ribbon is used.

However, ensure to initialize ink ribbon when initial-

ization is activated using the RESET button.

Even when not connected to the host computer, test print-

ing of built-in patterns can still be done in the Ready mode

by pressing the RESET and CLEAN buttons simulta-

neously for more than 1 second (a "beep" sound will be

heard from the buzzer) and releasing it. Refer to "Check-

ing After Changing the Thermal Head" in the Startup Guide

(P.34).

The setting of this printer can be switched between the

Standard mode and Fine mode for both YMC (color) print-

ing and K Resin (text) printing by using the setting func-

tion in the status monitor (Printer setting tool). When car-

rying out double-sided printing on the card, the same mode

setting will apply to both the front and rear faces. (Setting

a separate mode for the front and back is not possible.)

A longer printing time will be required when set to the

Fine mode. The merits of using Fine mode printing and

reference values on the printing time are shown below.

Additional Time when Set

to Fine Mode

YMC

Approx. 5 sec / side

K Resin

Approx. 2 sec / side

Merits of Using Fine Mode

Improvement in evenness,

texture and sharper outline

Lesser broken and faded words