DockStar Smart Thruster Instrukcja instalacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt żeglarski DockStar Smart Thruster. DockStar Smart Thruster 16 stron. Stern
Również dla DockStar Smart Thruster: Instrukcja obsługi (15 strony)
Drukuj stronęThe top of the T-track assembly is on the right. The top fitting is standard deck hinge that mounts with
two 10-32 flat-head screws. The bottom fitting is a swivel hinge that also mounts with two 10-32 flat
head screws. There is a rubber spacer that fits underneath the swivel part of this hinge. Be careful not
to drop this spacer into the water when installing the hinge! It is required for this hinge to function
properly.
The length of the T-track is 22". The length of the stainless tube is 25". The overall length with top and
bottom hinges attached is 29.5". DockStar can provide a shorter track and tube on request for smaller
sterns.
There are two cleats mounted on the sides of the T-track assembly at the top. These are used to secure
the lanyard. Installation of the lanyard will be discussed at the end of this guide.
The block and sling in the upper left of the picture above are used to attach the lanyard to the thruster.
How this is done is discussed at the end of this document. The four 10-32 screws, fender washers, and
nylock nuts for mounting the two hinge fittings are shown in the upper center of the picture above. The
lanyard is shown in the upper right.
The T-track is positioned on the stainless tube such that the Smart Thruster will be held parallel to the
mounting surface of the T-track assembly. If the stern is curved, the thruster will be parallel to the
tangent of the curved stern at the point of mounting. This may mean that the thruster is not
perpendicular to the keel of the boat. This is typical and does not present a performance issue.
That's it. Four screws installed into the stern and you're done except for the lanyard which is described
at the end of this document.
Thruster Deployed
Thruster Retracted
In Sand Piper's installation it was necessary to place a spacer block made out of Starboard plastic to
provide clearance past the gunwale trim. The spacer block is visible (if you look closely) in the pictures
above.
Page 3/ 16