DockStar Smart Thruster Kurulum Kılavuzu - Sayfa 3

Tekne Ekipmanları DockStar Smart Thruster için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. DockStar Smart Thruster 16 sayfaları. Stern
Ayrıca DockStar Smart Thruster için: Kullanım Kılavuzu (15 sayfalar)

Sayfayı Yazdır

The top of the T-track assembly is on the right. The top fitting is standard deck hinge that mounts with

two 10-32 flat-head screws. The bottom fitting is a swivel hinge that also mounts with two 10-32 flat

head screws. There is a rubber spacer that fits underneath the swivel part of this hinge. Be careful not

to drop this spacer into the water when installing the hinge! It is required for this hinge to function

properly.

The length of the T-track is 22". The length of the stainless tube is 25". The overall length with top and

bottom hinges attached is 29.5". DockStar can provide a shorter track and tube on request for smaller

sterns.

There are two cleats mounted on the sides of the T-track assembly at the top. These are used to secure

the lanyard. Installation of the lanyard will be discussed at the end of this guide.

The block and sling in the upper left of the picture above are used to attach the lanyard to the thruster.

How this is done is discussed at the end of this document. The four 10-32 screws, fender washers, and

nylock nuts for mounting the two hinge fittings are shown in the upper center of the picture above. The

lanyard is shown in the upper right.

The T-track is positioned on the stainless tube such that the Smart Thruster will be held parallel to the

mounting surface of the T-track assembly. If the stern is curved, the thruster will be parallel to the

tangent of the curved stern at the point of mounting. This may mean that the thruster is not

perpendicular to the keel of the boat. This is typical and does not present a performance issue.

That's it. Four screws installed into the stern and you're done except for the lanyard which is described

at the end of this document.

Thruster Deployed

Thruster Retracted

In Sand Piper's installation it was necessary to place a spacer block made out of Starboard plastic to

provide clearance past the gunwale trim. The spacer block is visible (if you look closely) in the pictures

above.

Page 3/ 16