ClipperCreek CS EVSE Pedestal Instrukcja instalacji - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Stojaki i stojaki ClipperCreek CS EVSE Pedestal. ClipperCreek CS EVSE Pedestal 20 stron. Electric vehicle supply equipment

Drukuj stronę

CS EVSE PEDESTAL INSTALLATION GUIDE

ClipperCreek

MOUNTING THE EVSE(s) and FINAL PEDESTAL INSTALLATION

, Inc.

12..

Mounting Two EVSE to the Pedestal

For an installation with two EVSE affixed to the

same post, the CS Dual-Mount Kit provides two side

brackets to be used in place of the single back bracket.

This operation should be performed by two

installers, one to hold the EVSE in place

while the other secures the pedestal hardware

•

Place a 1/4" Neoprene-bonded sealing washer

around the shaft of eight (8) 1/4" - 20 x 1" Torx

button-head screws. The metal portion of the

washer should face the head of the screw while

the neoprene should face the tip of the screw.

•

Pull the three conductor wires into the

enclosure and insert the threaded end of the 90

degree conduit fitting into the open aperture.

•

Align the four screw holes on the side flanges

of the first EVSE with the corresponding

screw holdes in the front mounting plate.

•

Align the two threaded inserts of each side

bracket with the corresponding screw holes

either side of the EVSE and mounting plate.

•

Secure the EVSE to the pedestal mounting

plate and bracket with the four (4) 1/4" - 20 x

1" Torx button-head screws (with washers)

using a T27 Torx driver.

•

Repeat for the second EVSE.

Figure.16:.Mounting Two EVSE with Side Brackets

13..Seal.the.Conduit.and.Enclosure

It is necessary to ensure a good environmental seal

between the conduit piece and the rear wall of the

EVSE.

•

Thread the remaining conduit locknut onto the

conduit fitting and hand-tighten it until it is snug.

See.Figure.17..

Apply silicone sealant to fill the conduit where

it enters the enclosure. Use a sufficient quantity

of silicone to ensure that no water or debris may

enter the enclosure through the conduit.

Figure.17:.Tighten.the.Conduit.Lock.Nut

Page 16