ClipperCreek CS EVSE Pedestal Instrukcja instalacji - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Stojaki i stojaki ClipperCreek CS EVSE Pedestal. ClipperCreek CS EVSE Pedestal 20 stron. Electric vehicle supply equipment
Drukuj stronęCS EVSE PEDESTAL INSTALLATION GUIDE
ClipperCreek
INITIAL PEDESTAL INSTALLATION (continued)
, Inc.
8..Install.the.CS.EVSE.Mounting.Plate(s)
An EVSE mounting plate is affixed to the front of
the pedestal post to provide flat and rigid base on
which the EVSE(s) can be mounted. In the case of a
Dual-Mount installation, a second mounting plate is
affixed to the opposite side of the pedestal post.
•
Hold the EVSE mounting plate against the
front side of the pedestal post with the notch
toward the left side to allow clearance
for the conduit as shown in Figure.12.
•
Align the two screw holes along the centerline
of the mounting plate with the corresponding
threaded inserts on the front of the pedestal
post.
•
Secure the mounting plate to the pedestal with
the two (2) 1/4 - 20 x 3/4" Torx flat-head tapered
screws using a T27 Torx driver. Tighten until
the head of the screw is flush with the surface
of the mounting plate.
For.Dual-Mount.EVSE.Installations:
•
The Dual-Mount Kit includes a second EVSE
mounting plate. This second mounting plate is
affixed to the back side of the pedestal post,
opposite of the first mounting plate.
•
As with the first mounting plate, align the two
screw holes and tighten two (2) 1/4" - 20 x 3/4"
Torx flat-head tapered screws using a T27
Torx driver until the screw head is flush with
the surface of the mounting plate.
Figure.12:.The.CS.EVSE.Mounting.Plate
9..
Install the Single CS EVSE Back Bracket
A bracket with threadeded inserts is included with the
pedestal kit to make the installation more rigid and to
provide threadeded inserts for mounting the EVSE.
Note that this bracket is not used for dual
EVSE installations.
•
The top edge of the bracket is flush along its
length, while the bottom edge of the bracket
has a metal notch in the middle to
accommodate a screw hole.
•
Hold the bracket against the back side of the
pedestal post with the flanges coming into
contact with the rear of the previously
installed EVSE mounting plate.
•
Align the two screw holes along the centerline
of the bracket with the corresponding threaded
inserts on the back of the pedestal post.
•
Place a 1/4" Neoprene-bonded sealing washer
around the shaft of two (2) 1/4" - 20 x 1" Torx
button-head screws. The metal portion of the
washer should face the head of the screw while
the neoprene should face the tip of the screw.
Note that the neoprene washer must be used
to maintain a watertight seal.
•
Secure the bracket to the pedestal with two (2)
1/4" - 20 x 1" Torx button-head screws (with
washers) using a T27 Torx driver.
Figure.13:.The.Single.CS.EVSE.Back.Bracket
Page 14