ClipperCreek CS EVSE Pedestal Instrukcja instalacji - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Stojaki i stojaki ClipperCreek CS EVSE Pedestal. ClipperCreek CS EVSE Pedestal 20 stron. Electric vehicle supply equipment

Drukuj stronę

CS EVSE PEDESTAL INSTALLATION GUIDE

INITIAL PEDESTAL INSTALLATION (continued)

ClipperCreek

, Inc.

For.the.Optional.1".Conduit.Assembly:

Some installations may require a conduit larger

than the standard ¾" assembly. For this purpose,

an optional 1" conduit assembly may be requested.

Follow these instructions and refer to Figure.10.to

install the optional 1" conduit.

•

It is highly recommended that connection

to the Ground Lugs inside the Pedestal Post be

completed at this time. Access will be limited

after.this.step.

•

Remove the 1" plastic plug located 3" down

from the top of the pedestal on the left side.

•

Unscrew the locknuts on either end of the

conduit.

•

Route the three conductors through the

following:

a) The inner locknut (inside of the pedestal)

b) The open pedestal hole

c) The first plastic washer (make sure the

washer is on the outside of the pedestal)

d) The conduit assembly

e) The second plastic washer (make sure

the washer is on the outside of the EVSE)

f) The outer locknut

•

The 1" conduit assembly may be disassembled

to make it easier to pull the conduit through

each fitting. Ensure the conduit is fully

reassembled before proceeding.

•

IMPORTANT: Remove the locknut (f) at

the end of the conduit assembly; this will

be.needed.in.a.later.step..See.locknut.(f).in..

Figure.10..Face the open end of the 90 degree

conduit fitting forward for later insertion into

the back of the EVSE.

Figure.10:.Optional.1".Conduit.Assembly

Page 12