ClipperCreek CS EVSE Pedestal Instrukcja instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Stojaki i stojaki ClipperCreek CS EVSE Pedestal. ClipperCreek CS EVSE Pedestal 20 stron. Electric vehicle supply equipment
Drukuj stronęCS EVSE PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
TOOLS REQUIRED FOR ASSEMBLING THE CS PEDESTAL
The following tools are required for the installation and assembly of the pedestal components:
T27 Torx Driver, in a variety of lengths for faster assembly. (Alternatively, a ratcheting driver
•
.
.
can.be.used..If.using.a.powered.screwdriver,.set.it.to.a.low.torque.value.)
•
#2 Phillips Head Screwdriver
•
Box Wrench (appropriately sized for the Anchor Nuts)
•
Tube of Silicone Sealant
TOOLS REQUIRED FOR WIRING THE CS EVSE
The following tools are required for wiring the service conductors to a CS EVSE rated for a branch
circuit of up to 60A:
•
T15 Torx Driver (for EVSE Door Access)
•
3/16" Flathead Screwdriver (for Ground Block Lug)
•
1/4" Flathead Screwdriver (for Contactor Lugs)
The following tools are required for wiring the service conductors to a CS EVSE rated for a branch circuit
greater than 60A:
•
T15 Torx Driver (for EVSE Door Access)
•
5/16" Flathead Screwdriver (for Ground Block Lug)
•
5/32" Hex Head Wrench (for Contactor Lugs)
Page 6