ClipperCreek CS EVSE Pedestal Panduan Instalasi - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Rak dan Dudukan ClipperCreek CS EVSE Pedestal. ClipperCreek CS EVSE Pedestal 20 halaman. Electric vehicle supply equipment
Halaman CetakCS EVSE PEDESTAL INSTALLATION GUIDE
ClipperCreek
, Inc.
TOOLS REQUIRED FOR ASSEMBLING THE CS PEDESTAL
The following tools are required for the installation and assembly of the pedestal components:
T27 Torx Driver, in a variety of lengths for faster assembly. (Alternatively, a ratcheting driver
•
.
.
can.be.used..If.using.a.powered.screwdriver,.set.it.to.a.low.torque.value.)
•
#2 Phillips Head Screwdriver
•
Box Wrench (appropriately sized for the Anchor Nuts)
•
Tube of Silicone Sealant
TOOLS REQUIRED FOR WIRING THE CS EVSE
The following tools are required for wiring the service conductors to a CS EVSE rated for a branch
circuit of up to 60A:
•
T15 Torx Driver (for EVSE Door Access)
•
3/16" Flathead Screwdriver (for Ground Block Lug)
•
1/4" Flathead Screwdriver (for Contactor Lugs)
The following tools are required for wiring the service conductors to a CS EVSE rated for a branch circuit
greater than 60A:
•
T15 Torx Driver (for EVSE Door Access)
•
5/16" Flathead Screwdriver (for Ground Block Lug)
•
5/32" Hex Head Wrench (for Contactor Lugs)
Page 6