DOF Reality M2 Instrukcje konfiguracji - Strona 11
Przeglądaj online lub pobierz pdf Instrukcje konfiguracji dla Akcesoria do gier wideo DOF Reality M2. DOF Reality M2 15 stron.
Również dla DOF Reality M2: Instrukcje konfiguracji (14 strony)
Drukuj stronę
B) If in the Model box you see "Connected".
But the platform is not moving with "Tests" in the SRS Software contact
C) If your platform is moving fine in Tests, but not in the games, first make sure SRS is
running while you are playing the game. If the platform is still not moving, you need to
click the Auto Install button in SRS. For games changes in game settings following this
guide
https://www.simracingstudio.com/download
If the platform still doesn't move, you should create a ticket by emailing
extremely helpful.
5.2 If one or more of your motors are stuck in an improper position and
don't seem to respond
If a motor gets into the "protection zone", it may stop responding. If this occurs, the mechanical position
is so far out of line that the software locks. To unlock it:
1) Power off both control boxes
2) Close all SRS applications
3) Download
http://dofreality.com/SMC3Utils.zip
4) Unzip all archive contents into any local folder on your PC
5) Open with notepad file SMC3Utils.ini and set COMM_PORT= to correct COM port number
from your Windows Device Manager (see 5.1) Each control box has a specific port number. Test
one box at a time.
6) Start/run SMC3Utils.exe. If you are getting an error messages about the COM port
communication, you haven't set the port number properly in the previous step.
7) Select the problematic motor . Most commonly, in the SRS application, the motor will be
shown as OFF and the green line on the chart for it is below the blue line. Disconnect
corresponding motor vertical silver links from the black motor arm so motor black arm can
rotate freely 360 degree.
8) Write down current Max Limits and Clip Input values (on the right of the SMC3Utils window)
and reduce them to 0. Normal is Max Limit 50, and Clip Input is 190.
9) In SMC3Utils click small OFF button in the top left-hand part of the screen, so it becomes ON.
Select the button next to the motor you are adjusting. If you can't set motor to ON, zero all
other motors Clip Input and Max Limit to unlock it as one motor locks all.
10) Power ON the platform
11) The motor should move back to normal position. If you want to check the motion, you can
select the 'Sine' radio button and see that it moves appropriately. The green line is a reflection
of the measured motor position (where it actually is), the blue line is the desired motor position
(where it theoretically should be). These will not be perfectly aligned, but should be close. 2) If
the motor arm has recalibrated, reset the original Max Limits and Clip Input values (you need to
increase Clip first and then Max as max cannot be bigger than Clip) and close SMC3Utils.
11
Setup Instructions DOF Reality M2
with as much information as possible, screenshots would be
.