Ashcroft DG25 Instrukcja instalacji i obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Przyrządy pomiarowe Ashcroft DG25. Ashcroft DG25 16 stron. Digital pressure gauge
Drukuj stronę
6. To program minimum graph percentage,
the display will indicate 0 0 with the right
digit flashing, the bottom most segment
of the bar graph will flash, and the dis-
play will read "PCTFS" (percent full
©
scale). Press
num-ber 0-9. Press
num-ber. The left digit will now begin to
©
flash. Press
,
©
k
number 0-9.
number. The 2 digit number entered
represents the percentage of full scale
to be used as the low end of the graph
(0-99%).
7. To program maximum percentage of full
scale the display will indicate 1 0 0 with
the right digit flashing, the upper most
segment of the graph will flash, and the
display will read PCTFS (percent full
©
scale). Press
,
a number 0-9. Press
that number. The left 2 digits will now
begin to flash. Press
scroll to a number 0-10. Press
select that number. The number entered
represents the percentage of full scale
to be used as the high end of the graph.
Note: 100 is the highest and only possi-
ble 3 digit number. If the low number is
equal to or larger than the high number,
the unit will flash "REJCT"
and it will exit back into the "GRAPH"
sub-menu.
Note: Custom graph function is not available
on vacuum and compound ranges.
Note: A display message "ULOCK" indicates
that custom units are being used and bar
graph minimum and maximum are set to
the factory defaults
©
,
to scroll to a
©
k
to select that
©
. to scroll to a
. to select that
©
. to scroll to
©
k
to select
©
©
,
to
©
k
to
Reset:
Returns the product to the factory default val-
ues.Preserves field calibration. Factory calibra-
tion can be restored in the "RECAL" menu.
1. In menu mode
"RESET" appears on display's lower line;
©
k
.
Factory defaults pertain to units, timer,
back light, update rate, zero lock.
Display will indicate "DONE" then gauge
will switch to "OFF" condition.
13
©
©
,
until