Dolby Laboratories CP750 Instrukcja instalacji - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt komputerowy Dolby Laboratories CP750. Dolby Laboratories CP750 19 stron. 7.1 audio for the dolby multichannel amplifier
Drukuj stronę
- 1. Introduction to Dolby Cp750 7.1 Audio for the Dolby Multichannel Amplifier
- 2. About the Cp750 (or Other Cinema Processor) Configuration for the
- 3. Connecting a Cp750 (or Other Sound Processor) to a Media Block
- 4. Configuring Advanced Connections
- 5. Cp750 Audio Output Cable Pinouts
- 6. To 25-Pin D-Connector Digital Audio Pinouts
Note: To display the Yamaha device as input stream 1, the device must be connected to
the amplifier.
8. Select Routing in the navigation bar to display the Output routing screen, and enter the
routing input for the assigned speakers.
In this Output Routing screen, you can route channels from any of the five input streams to
one or more speaker outputs. Input streams and the respective UDP ports appear on the left
side of the screen, while outputs are listed on top. The UDP ports correspond to the UDP
settings in the Network>Dolby Atmos Connect screen. The amplifier is shipped with no
routing assignments, and there is no audio transmitted until you configure routing.
To configure bridged channels, you must select Power in the navigation bar before setting
up your routing assignments.
To configure routing, click in an output box in the row next to the desired input stream and
the box is highlighted in blue to show the corresponding routing output. If you click again in
a highlighted box, that assignment is removed.
If you click the Auto-route button, the system looks for every available input channel, and
assigns consecutive outputs to consecutive inputs.
Clicking Unassign all removes the routing assignments.
In the following figure, channels 1 and 2 and channels 3 and 4 are bridged. However, you can
assign individual inputs to one or more outputs, but cannot assign multiple inputs to an
output.
Here is a typical routing configuration:
1 = Left
2 = Right
Dolby CP750 7.1 audio for the Dolby Multichannel Amplifier Installation Manual
7 May 2018 Issue 1
Setting up the system
15