CYP CH-1527TXPL Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przedłużacz CYP CH-1527TXPL. CYP CH-1527TXPL 14 stron. Cyp ch-1527txpl; ch-1527rxpl hdmi over cat5e/6/7 extender with ir/rs-232/poe

Drukuj stronę
CYP CH-1527TXPL Instrukcja obsługi
3. 6. OPERATION CONTROLS AND FUNCTIONS

6.1 Transmitter Front and Rear Panels

Front
IR1
BLASTER
IR2
DC 48V
EXTENDER
1
2
3
1
DC 48V: Plug the 48V DC power supply into the unit and connect
the adaptor to an AC outlet.
2
IR1 BLASTER: Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
3
IR2 EXTENDER: Connect to the supplied IR Extender cables for IR
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.
4
CAT5e/6/7 OUT: Connect to the Receiver unit with a single
CAT5e/6/7 cable for transmission of all data signals.
5
HDMI IN: Connect to HDMI source equipment such as a DVD or
Blu-ray player.
STD/UPDATE Switch: This switch is reserved for factory use only.
6
7
RS-232 IN: Connect to a PC or Laptop with D-Sub 9-pin male cable
for the transmission of RS-232 commands.
8
POWER LED: This LED will illuminate when the device is connected
to a power supply.
9
LINK LED: This LED will illuminate when both the input source and
output display signals are connected through CAT cable. When
it blinks regularly it states the display is NOT sending signals to
Receiver but the Transmitter and Receiver are linked and if it blinks
irregularly it states an error has occurred.
3
HDMI IN
4
5
Rear
RS-232 IN
STD UPDATE
6
7
POWER
LINK
8
9