CYP CH-1527TXPL Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przedłużacz CYP CH-1527TXPL. CYP CH-1527TXPL 14 stron. Cyp ch-1527txpl; ch-1527rxpl hdmi over cat5e/6/7 extender with ir/rs-232/poe
Drukuj stronę
6.2 Receiver Front and Rear Panels
Front
IR2
BLASTER
IR1
EXTENDER
1
2
1
IR2 BLASTER: Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
IR1 EXTENDER: Connect to the supplied IR Extender cables for IR
2
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.
3
CAT5e/6/7: Connect to the Transmitter unit with a single CAT5e/6/7
cable for transmission of all data signals.
HDMI OUT: Connect to a HDMI equipped TV/monitor for display of
4
the HDMI input source signal.
5
STD/UPDATE Switch: This switch is reserved for factory use only.
6
RS-232 OUT: Connect to the device that is to be controlled (via
D-Sub 9-pin female cable) by RS-232 commands.
7
POWER LED: This LED will illuminate when the device is connected
to a power supply.
8
LINK LED: This LED will illuminate when both the input source and
output display signals are connected through CAT cable. When
it blinks regularly it states the display is NOT sending signals to
Receiver but the Transmitter and Receiver are linked and if it blinks
irregularly it states an error has occurred.
HDMI OUT
3
4
Rear
RS-232 OUT
STD UPDATE
5
6
POWER
LINK
7 8
4