CYP CHDBT-1H3CE Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kable i złącza CYP CHDBT-1H3CE. CYP CHDBT-1H3CE 16 stron. 1×4 hdmi over hdmi and cat5e/6/7 splitter with poe and lan serving
Również dla CYP CHDBT-1H3CE: Instrukcja obsługi (13 strony)

Drukuj stronę
CYP CHDBT-1H3CE Instrukcja obsługi

6.2 Rear Panel

IR IN
1
IR IN: Connect the supplied IR Receiver cable for IR signal
1
reception. Ensure that remote being used is within the direct line-
of-sight of the IR Extender.
IR OUT: Connect the supplied IR Blaster cable for IR signal
2
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
3
LAN: Connect to an active network for LAN serving. When any
compatible LAN equipped receivers are connected, this allows
the network access (including internet access if available) to be
shared. Connect any Ethernet equipped device e.g. a Smart TV
or games console to the LAN port of a receiver for that device to
share the network/internet access.
Warning: DO NOT connect the LAN connection with any of the
CAT5e/6/7 outputs, doing so may trigger a power shut down and
may damage the device.
4
CAT5e/6/7 OUT 1~3: Connect to CAT5e/6/7 to HDMI Receivers (with
or without PoE) with a single CAT5e/6/7 cable each to extend the
HDMI signal up to 100 m.
MODE LED: This LED will illuminate when the power is connected.
LINK LED: This LED will illuminate when connected to a Receiver unit
that is connected to a TV/monitor that is displaying the signal.
IR OUT
LAN
2
3
CAT5e / 6 / 7 OUT
1
2
MODE
LINK
MODE
LINK
4
3
MODE
LINK
4