Cypress CY3203-CapSense Skrócona instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Płyta główna Cypress CY3203-CapSense. Cypress CY3203-CapSense 20 stron. Psoc express

Drukuj stronę

Use the Board as Factory Programmed

Test the Board

2.5.

Touch the slider on the board with your finger. The LCD shows the hexidecimal number representing

where your finger is on the slider. The block on the LCD changes position as you move you finger

across the slider.

2.6.

Touch one button at a time with your finger. The LCD shows the hexidecimal number representing the

button being pressed.

Resetting the Board to the Original Factory Programming

Follow these steps if you wish to reset the board to the original factory installed programming:

2.7.

Download the CSA_7_Button_Slider example project at:

http://www.cypress.com/design/DK10068

2.8.

To reset the board to the factory conditions, connect your computer to the CapSense test

board ISSP Connector (J2) using the PSoC MiniProg and a USB cable.

2.9.

Open PSoC Programmer by going to the Windows Start menu and selecting:

All Programs

grammer

2.10. Click File Load, navigate to, and open the csa_7_button_slider.hex file at:

CSA_7_Button_Slider/output/csa_7_button_slider.hex

2.11. From the Device Family menu, select 20x34.

2.12. From the Device menu, select CY8C20434-12LFXC.

2.13. Click Program. "Programming Succeeded..." appears in the Actions pane when programming is com-

plete.

Note: The CSA_7_Button_Slider example project is a PSoC Designer project, and will not open with PSoC

Express. PSoC Programmer uses .hex files generated with both PSoC Express and PSoC Designer.

Cypress MicroSystems

CY3203A-CapSense Quick Start Guide, Spec. # 001-17826 Rev. *A

PSoC Programming

PSoC Pro-