Ashly CLX-52 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt muzyczny Ashly CLX-52. Ashly CLX-52 12 stron. Compressor/limiter
Również dla Ashly CLX-52: Uwagi techniczne i specyfikacje (2 strony), Uwagi techniczne i specyfikacje (2 strony), Instrukcja obsługi (12 strony)

Ashly CLX-52 Instrukcja obsługi
Operator Manual – CLX-52 Compressor/Limiter
CLX-52 Rear Panel
1.
Inputs and Outputs - Your CLX-52
Compressor/Limiter is provided with three
different connector types. 1/4" TRS (tip-ring-
sleeve) jacks, XLR connectors and Euroblocks.
Inputs are 20KΩ active balanced using 1%
metal film resistors, outputs are 132Ω servo-
balanced.
2.
Detector Loop - Ducking - The CLX-52
Compressor/Limiter has a TRS Insert

Installation

Use four screws and paint-piercing washers when rack mounting the CLX-52. For mobile
use, the unit should be further secured as appropriate.

General Requirements

The CLX-52 has specific physical, electrical and signal requirements for proper operation.
These requirements will vary depending on your specific application, setup, and the
settings on the unit. When setting up and testing your system, please take special care to
double check all connections and settings. Please refer to the specifications section of this
manual for specific input, output and other figures.
AC Power
Your CLX-52 should be connected to a standard 3-wire grounded electrical outlet
supplying 100-240 Volts, 50-60 Hz. To reduce the risk of ground loop hum, connect all
audio equipment to the same electrical power source. Do not remove the AC plug ground
pin, as a potential shock hazard could result.
This unit will perform normally within the AC voltage range specified above. Voltages
less than this, as found in "brown-out" conditions, may reduce performance. No user
serviceable parts are inside the chassis. Refer all servicing to qualified service personnel.
Overall power consumption is less than 30 watts.
NOTE: The power switch does NOT isolate the appliance from mains. Make sure the mains
power socket or an alternative disconnect device is near by and easily accessible. When the
product is connected to mains, the line-filter and the input of the fuse are energized.
DETECTOR PATCH point which can be used
as a "ducking" input, or in conjunction with an
equalizer to produce frequency-sensitive
limiting. Various uses of the detector patch are
discussed under Typical Applications.
3.
Power – Switches the unit power on or off
All Rights Reserved
Page - 7
Introduction - 4
CLX-52 – 5
Connectors & Cables – 5
Physical Description - 6
Installation – 7
General Requirements
AC Power
Typical Applications - 8
Troubleshooting - 9
Dimensions - 9
Specifications - 10
Warranty - 10