BlueParrott C400-XT Podręcznik użytkownika - Strona 9
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Zestawy słuchawkowe BlueParrott C400-XT. BlueParrott C400-XT 19 stron.
Również dla BlueParrott C400-XT: Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (4 strony)
Drukuj stronę
GETTING STARTED
On/Off/Standby
Turn Headset On: Hold down the MFB for approximately 2-3 seconds until you hear a voice prompt,
"power on ." The red light will flash once every second .
Turn Headset Off (conserves battery power): Hold down the MFB for approximately 4–5 seconds
until you hear a voice prompt "power off ." A red light will flash 4 times and the headset will turn off .
Standby Mode: Once the headset is turned on (after the initial pairing), it will attempt to connect to
the last device that it was paired with, putting itself into Standby Mode .
Pairing with a Phone
When you turn your C400-XT on for the first time, or if its
Paired Device List has been cleared, it will go into pairing
mode automatically . You can pair the headset using NFC
or manually .
NFC (One-Touch) Pairing
1 . Make sure that NFC is enabled on your cell phone .
2 . Place the NFC zone of your cell phone against the NFC
zone of the headset and hold them together until your
cell phone registers the headset .
3 . Follow the prompts on your cell phone to complete
pairing .
Note: NFC and One-Touch Pairing are dependent on your
cell phone. The size and sensitivity of your phone's NFC
zone and the specific way to connect the headset may
vary between devices.
BlueParrott C400-XT User Guide
NFC Zone
PAGE 9