Ega Master EGATRONIK Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Ega Master EGATRONIK. Ega Master EGATRONIK 17 stron. Non-contact ac voltage detector
Również dla Ega Master EGATRONIK: Instrukcja obsługi (16 strony), Instrukcja obsługi (13 strony)

Drukuj stronę

The default reference setting is from the rear of the instrument.

Press this button

whenever the reference setting is changed. After a re-startup the reference returns automatically to

the default setting (rear reference).

Press this button

In a word, to select the reference level, push button

level is indicated in the display. Each time after switching on, the rear edge of the measuring tool is

preset as the reference level.

Click illumination button of the display can be switched on or off, User can trigger the

function when he/she is in darkness situation. The value is clear viable on the LCD.

Click the button longer change the next type of unit, m, ft. in, ft/in then to continue click the

button for the next unit selection.

Press to activate the laser. Press again to trigger the distance

measurement. The measured value is displayed immediately.

Continuous Measurement & Max and Min Measurement The continuous measurement function

(tracking) is used for the transferring of measurements, e.g., from construction plans. In continuous

measurement mode, the measuring tool can be moved close to the target, whereby the measured

value is updated approx. every 0.5 seconds. The corresponding dynamically maximum and

minimum values are displayed in the first and second line.

As an example, the user can move from a wall to the required distance, while the actual distance

can be read continuously. For continuous measurement, press

for continuous measurement appears in the display. And press it again or press

function.

The function is terminated after 5 minutes' continuous measurement.

With this function, customers can measure the max and min distance from a certain point.

to take the selection from the front edge

again to take the next selection from end piece edge.

, to set the rear reference again.

DISPLAY ILLUMINATION

DISTANCE UNIT SETTING FOR INSTRUMENT

MEASURING

SINGLE DISTANCE MEASUREMENT

. A special beep sounds

repeatedly until the required reference

button until the indicator

to stop the