Asko D3232 Instrukcja obsługi i konserwacji - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Zmywarka Asko D3232. Asko D3232 16 stron. User manual d3232 use & care guide fr (french ucg 2+1 warranty)
Również dla Asko D3232: Skrócona instrukcja obsługi (2 strony), (Hiszpański) Uso Y Cuidado (16 strony), (Angielski) Instrukcja obsługi (16 strony)

Drukuj stronę

Asko D3232 Instrukcja obsługi i konserwacji

RINSE AID DISPENSER

The rinse aid is released during the final rinse to prevent

water from forming droplets on your dishes that can

leave spots and streaks. It also improves drying by

allowing water to "sheet" off the dishes.

ASKO dishwashers are designed to use liquid rinse

aids. The rinse aid dispenser is located inside the door

next to the detergent dispenser. (See illustration on page

3.) To fill the dispenser, open the cap and pour the rinse

aid into the dispenser up to the knob for dosage setting.

The dispenser holds about four ounces of liquid rinse

aid.

Be careful not to overfill the dispenser, because this

could cause oversudsing. Wipe away any spills with a

damp cloth. Don't forget to replace the cap before you

close the dishwasher door.

If you have soft water, rinse aid may cause a white film to

develop on your dishes. You may not need rinse aid.

NOTE:

If you use a dishwashing detergent with a

rinse aid additive, you should not fill the

rinse aid dispenser. This could cause a film

on your dishes.

ADJUSTING THE AMOUNT OF RINSE AID DISPENSED

A measured amount of rinse aid is released during the

final rinse. As with detergent, the amount of rinse aid

needed for your dishes depends on the hardness of the

water in your area. (See page 5.) Too much rinse aid

can result in lather or foaming and cause cloudiness or

streaks on your dishes. If the water in your area is very

soft, you may not need rinse aid. If you do, you can dilute

the rinse aid with an equal amount of water.

Rinse aid

adjustment dial

RINSE

AID INDICA

AID INDICAT T T T T OR LIGHT

AID INDICA

RINSE AID INDICA

RINSE

AID INDICA

This model has an indicator on the control panel that

displays when the rinse aid dispenser is nearly empty

(see page 8). After you refill the dispenser, there may be

some delay before this indicator light goes out.

Page 6

To increase the amount of rinse aid released

in the final rinse, turn the adjustment dial to

the next higher number.

NOTE

OR LIGHT

To open the dispenser, turn the cap to the "open"

(left) arrow and lift it out.

Pour the rinse aid into the dispenser, being careful

not to overfill.

Replace the cap by inserting it aligned with "open"

arrow and turning it to the closed (right) arrow.

The rinse aid dispenser has six settings. Always start

with the dispenser set on "1." If spots and poor drying

are problems, increase the amount of rinse aid

dispensed by removing the dispenser lid and rotating

the dial to "2." If the dishes still aren't drying properly or

are spotted, adjust the dial to the next higher number

until your dishes are spot-free.

: : : : :

Only adjust the dial one number at a time.

Open

Closed

Dispenser

Cap