Ambient Weather WeatherHub2 Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Stacja pogodowa Ambient Weather WeatherHub2. Ambient Weather WeatherHub2 10 stron.

3. Connect the USB cable (provided with the weather station

or purchased separately) into the USB Port on the side of

the WeatherHub2 and into the weather station.

4. communication port. If you have a weather station with a

serial port, you will need a USB converter and serial cable

available here:

http://www.ambientweather.com/cousbto9sead.html

and

http://www.ambientweather.com/secoca6.html

5. Connect the AC power adaptor to the WeatherHub2. The

unit will turn on and the top status light will turn solid on

after approximately one minute.

6. After about 1 minute, Ethernet lights should both be solid

on. The WeatherHub2 is now ready to use.

Ambient Weather

6845 W. Frye Road

Chandler, AZ 85226

TEL 480-283-1644  FAX 480-346-3381

www.AmbientWeather.com

IP Addressing

The WeatherHub2 is programmed from the factory for dynamic

addressing (or DHCP). This allows to you to address the unit from

any computer on your network without modifying the IP address.

However, since it is dynamic, you will have to determine the

address that was assigned to the unit.

To determine this address, load and install the IPScan tool

provided on the CD. You can also download it here:

http://www.download25.com/install/free-ip-scanner.html

For Mac and Linux users, visit:

Page 2

Figure 1