Ambirad VISION COMPACT VC12 Manual de operação, manutenção e assistência técnica - Página 7

Procurar online ou descarregar pdf Manual de operação, manutenção e assistência técnica para Aquecedor a gás Ambirad VISION COMPACT VC12. Ambirad VISION COMPACT VC12 19 páginas. Gas fired radiant tube heaters

Imprimir página

9 Installation of Vision Compact

heater

Health & safety

A qualified installer is required to install the

appliance in accordance with the rules in

force, and should the need ever arise to

convert the appliance for use with other

Installation

There is no on site assembly required for the

VISION COMPACT of heater.

Attach an appropriate hanging attachment

to each of the four hanging brackets.

The heater can be installed with the

packaging in place to protect the casing

from damage during installation.

Raise the heater into the air and affix to the

chain previously located of 4mm (minimum)

gauge galvanised welded link construction.

Alternatively, 10mm diameter mild steel

drop rods can be used.

Figure 4 Mounting of Vision Compact heater

When chain supports have an angle

of inclination greater than

equal and opposite support is

recommended.

Vertical or inclined suspension

on this plane is acceptable.

Wall mounting brackets must support the

heater at an angle of inclination between

30˚ and 45˚, and are available from the

manufacturer. The angle can be varied by

adjusting the drop rods or chain on each

bracket. The bracket positions are critical

and when suspended they should have the

same orientation i.e. all the same angle.

Note When installing the heater at an angle

the combustion fan outlet should be

positioned so that it remains vertical.

It is recommended that sufficient clearance

from any fixed structure (e.g. a wall) is given

above the burner and behind the burner /

fan compartment to allow sufficient room

for the service of the heater. (See section 8

on clearances).

Note As a part of the heaters annual service

all dust deposits on the top of the reflector

should be removed before the start of each

heating season.

° an

Drop rod with

formed hook.

Shackle method of attachment. Pin must

be tightened by Pipe grips or Pliers.

Important

IMPORTANT

The heater should slope downwards towards the

towards the Return bend

These angles to be equal

and not more than 45°

Return Bend by approx. 10mm for both

horizontal and Wall mounted installations.

horizontal and wall mounted installations.

15° max

Vertical suspension chain ideal.

Where supports are inclined max.

recommended angle of inclination

: The Heater should

slope downwards

by approx. 10mm for both