Aktakom ATK-2021B Manual do utilizador - Página 12

Procurar online ou descarregar pdf Manual do utilizador para Instrumentos de medição Aktakom ATK-2021B. Aktakom ATK-2021B 17 páginas. Clamp meter

3.5. Resistance Measurement

3.5.1. Set the rotary switch at Ω .

3.5.2. Insert the test leads into the input jack.

3.5.3. Connect the test prods of the test leads to the two ends of the resistor or

circuit to be measured.

3.5.4. Read the measured value from the LCD display.

3.6.1. Turn the rotary switch to Ω position and move the sliding switch to AC

position.

3.6.2. Insert the test leads into the input jack.

3.6.3. Connect the test probes of the test leads to the two ends of the resistor or

circuit to be measured.

3.6.4. Read the measured value from the LCD display.

3.6.5. If the resistance is lower than 10 Ω, a beeping sound shall be heard.

3.7.1. Set the rotary switch at Hz.

3.7.2. Insert the test leads into the input jack.

3.7.3. Connect the test prods of the test leads in PARALLEL to the signal or

circuit to be measured.

3.7.4. Read the measured value from the LCD display.

3.8.1. Set the rotary switch at Duty.

3.8.2. Insert the test leads into the input jack.

3.8.3. Connect the test prods of the test leads in PARALLEL to the signal or

circuit to be measured.

3.8.4. Read the measured value from the LCD display.

3.9.1. Set the rotary switch at diode.

3.9.2. Insert the test leads into the input jack.

3.9.3. Connect the test prods of the test leads to the two ends of a diode.

3.9.4. Read the diode voltage from LCD.